Matching You with a Pre-Screened Smog Check Center You will Love
Free Online Smog Check Diagnosis
$500 Free Consumer Repair Assistance
Failed Emissions Test
How to Pass the Test
Who Else Wants To Pass the Smog Check
Miles: 
Which Type Should I Choose?
 
   
    Forum > Failed Smog Test > Question

Join the community and post your questions. Ask-A-Tech right now!
 
 



Failed Smog Test
 

1998 Toyota Camry Emission Monitors Not Ready

We were trying to get the trouble codes for check engine using an OBD Scanner! It got disconnected during test and check engine light disappeared . We took it in for smog check and it failed. The smog tech said we needed to drive it. After almost 2000 miles check engine light has not come back. We took it back to be retested and still failed. It shows that the Camry failed the OBD part of the test. The tech wrote something about the car having aftermarket parts. All we did to the car was replaced the hose from the engine to the air cleaner before the smog test.

Answer:  

Erasing or clearing the check engine light is actually resetting the engine control computer (ECU). This not only turns off the check engine light  but more importantly it erases any trouble codes and all the emission monitors. The "monitors" are internal tests which the ECU performs to check itself and specific systems related to engine emissions, i.e. the EGR system, the EVAP system, Catalyst, so on. In this specific case it appears all your Toyota Camry's monitors were erased due to the reset. You will need to complete a Toyota Camry drive cycle in order to set the emission monitors (make the monitors complete).

The Toyota Camry drive cycle below is designed for automatic transmission equipped Toyota Camrys' with 2.2L engines and CA approved emissions.

1998-2002 Toyota Camry Drive Cycle (Engine 1MZ-FE & 5S-FE - CA Emissions Certified)

Begin by: (Make sure you have between 1/4 and 3/4 fuel in the gas tank. The EVAP test will not run while your Toyota has a full tank of gas or the gas tank is near empty). Ensure there are no pending or active trouble codes and that the check engine light is not on.

    A. Start the engine and allow it to idle for 2 minutes or more.

    B. Drive the vehicle at 40-70 mph or more for at least 3 minutes. Be sure to maintain engine speed between 900 and 3,200 rpm.

    C. Stop the vehicle and allow the engine to idle for 10 seconds or more.

    D. Drive the vehicle at 25 mph for at least 40 seconds or more. Be sure to maintain engine speed above 900 rpm.

    E. Stop the vehicle and allow the engine to idle for 10 seconds or more.

    F. Perform steps “D” and “E” ten times.

    G. Drive the vehicle allowing speed to fluctuate between 35-45 mph for about 16 minutes.

If readiness status of all monitors do not switch to “complete,” ensure preconditions are met, turn the ignition switch OFF, then repeat steps “A” through “G.”

Completing the Toyota Camry drive cycle above should set the emission monitors required to pass the smog check. We recommend performing the drive cycle 2 or 3 times before the smog inspection.

Take caution when performing drive cycles on public roadways. If you feel you will be unable to complete the driving pattern above safely and legally, seek assistance from a reputable smog check repair station or Toyota repair facility.


posted by SmogTips Support
 


Related Toyota Camry Drive Cycle questions and answers you might find useful:

Is the Drive Cycle for a 1998 Toyota Camry V6 the Same as 2.2 Cycle? by James

Toyota Camry Engine Problem and CAT Monitor Not Ready by Roy

Toyota Camry Drive Cycle by KEN

1997 Toyota Camry Failed Smog Test Because Monitors Not Ready by eric

1997 Toyota Camry Failed Smog Test 3 Times by Phyllis